Cisco WAP131 Wireless-N Dual Radio Access Point with PoE
- AC Power Adapter
- Ethernet Network Cable
Cisco WAP131 Specs
| Standards |
IEEE 802.11n, 802.11g, 802.11b, 802.3af, 802.3u, 802.1X (security authentication), 802.1Q (VLAN), 802.1D (Spanning Tree), 802.11i (WPA2 security), 802.11e (wireless QoS), IPv4 (RFC 791), IPv6 (RFC 2460) |
| Cabling Type |
Category 5e or better |
| Antennas |
Internal antennas optimized for desktop installation with vertical orientation |
| LED Indicators |
Power, WLAN, LAN |
| Operating System |
Linux |
| Quality of Service (QoS) |
Wi-Fi Multimedia and Traffic Specification (WMM TSPEC), Client QoS |
| System Memory |
RAM: 128 MB
Flash: 128 MB |
| Minimum Requirements |
Switch or router with PoE support, PoE injector, or AC power adapter
Web-based Configuration: Java-enabled web browser |
| Ports |
10/100/1000 Ethernet, with support for 802.3af/at PoE, Power Port for AC adapter |
| Power Supply |
External 12 V, 1.5 A DC power jack (Energy Star 2.0 compliant with Efficiency Level 5) and 802.3af/at PoE |
| Buttons |
Reset button, Power (on/off), Push button |
| Cable Lock Slot |
Slot for Kensington lock |
| LEDs |
Power, Wireless, Ethernet |
| VLAN Support |
Yes |
| Number of VLANs |
1 management VLAN plus 8 VLANs for SSIDs |
| 802.1X Supplicant |
Yes |
| SSID-to-VLAN Mapping |
Yes |
| Auto Channel Selection |
Yes |
| Spanning Tree |
Yes |
| Load Balancing |
Yes |
| IPv6 |
IPv6 host support
IPv6 RADIUS, syslog, Network Time Protocol (NTP), etc. |
| Layer 2 Features |
802.1Q-based VLANS, 8 active VLANS plus 1 management VLAN |
| WPA/WPA2 |
Yes, including Enterprise authentication |
| Access Control |
Yes, management access control list (ACL) plus MAC ACL |
| Secure Management |
HTTPS |
| SSID |
Yes |
| Wireless Throughput |
Up to 300 Mb/s data rate (real-world throughput will vary) |
| Recommended User Support |
Up to 32 connective users, 16 active users per radio |
| Web User Interface |
Built-in web user interface for easy browser-based configuration (HTTP/HTTPS) |
| Management Protocols |
Web browser, Simple Network Management Protocol (SNMP) v3, Bonjour |
| Remote Management |
Yes |
| Event Logging |
Local, remote syslog, email alerts |
| Network Diagnostics |
Logging and packet capture |
| Firmware Upgrade |
Firmware upgradable through web browser, imported/exported configuration file |
| Dynamic Host Configuration Protocol (DHCP) |
DHCP client |
| IPv6 Host |
Yes |
| Frequency |
Dual concurrent radios (2.4 and 5 GHz) |
| Radio and Modulation Type |
Dual radio, orthogonal frequency division multiplexing (OFDM) |
| WLAN |
802.11n
2×2 multiple-input multiple-output (MIMO) with 2 spatial streams
20 and 40 MHz for 802.11n
PHY data rate up to 600 Mb/s |
| Data Rates Supported |
802.11a/b/g:
54, 48, 36, 24, 18, 12, 9, 6, 11, 5.5, 2, and 1 Mb/s802.11n: 6.5 to 300 Mb/s
20 MHz Bandwidth: MCS 0-15 for supported data rates
40 MHz Bandwidth: MCS 0-15 for supported data rates |
| Frequency Band and 20 MHz Operating Channels |
A Regulatory Domain:
2.412 to 2.462 GHz; 11 channels
5.180 to 5.240 GHz; 4 channels
5.745 to 5.825 GHz; 5 channelsE Regulatory Domain:
2.412 to 2.472 GHz; 13 channels
5.745 to 5.805 GHz; 4 channels |
| Nonoverlapping Channels |
Maximum Channels:
@2.4 GHz; 802.11b/g; 802.11n; 20 MHz: 3
@5 GHz; 802.11a; 802.11n; 20 MHz: 9
@5 GHz; 802.11a; 802.11n; 40 MHz: 3 |
| Wireless Isolation |
Wireless isolation between clients |
| Internal Antennas |
Internal fixed PiFA antenna |
| Antenna Gain In dBi |
Maximum antenna gain of 3.4 dBi on 2.4 GHz
Maximum antenna gain of 4.5 dBi on 5 GHz |
| Wireless Distribution System (WDS) |
Yes |
| 802.11i Security |
Yes |
| Multiple SSIDs |
8 |
| Wireless VLAN Map |
Yes |
| WLAN |
Yes |
| Wi-Fi Multimedia (WMM) |
Yes, with unscheduled automatic power save |
| Access point |
Access Point mode, WDS Bridging, Workgroup Bridge mode |
| Power Options |
IEEE 802.3af/at Ethernet switch
Cisco Power Injector: SB-PWR-INJ2-xx (not included)
AC Adapter: Included 12 V, 1.5 A
PoE Peak Power: 7.42 W |
| Compliance |
Safety:
UL 60950-1
CAN/CSA-C22.2 No. 60950-1
IEC 60950-1
EN 60950-1Radio approvals:
FCC Part 15.247, 15.407
RSS-210 (Canada)
EN 300.328, EN 301.893 (Europe)
AS/NZS 4268.2003 (Australia and New Zealand)
EMI and susceptibility (Class B):
FCC Part 15.107 and 15.109
ICES-003 (Canada)
EN 301.489-1 and -17 (Europe) |
| Operating Temperature |
32 to 104°F / 0 to 40°C |
| Storage Temperature |
-4 to 158°F / -20 to 70°C |
| Operating Humidity |
10 to 85% non-condensing |
| Storage Humidity |
5 to 90% non-condensing |
| Mounting Options |
Desktop |
| Dimensions |
6.7 x 6.7 x 1.4″ / 17.0 x 17.0 x 3.6 cm |
| Weight |
0.89 lb / 0.40 kg |
